so I'm looking at the sample drill #1 trying to figure out how to recreate this (especially to setup the symbols properly). If I'm looking at this drill properly did the drill writer start on set 2 and work backwards to when starting the drill. I'd like to start my drill with an integrated set like this and then pull them apart but can't seem to figure out how to individually place each member on the grid?
thanks in advance,
bpb
los angeles ca
sample drill setup
Moderator:PywareTechSupport
Re: sample drill setup
Bob
I would suggest that you go through the tutorial. This will help you accomplish what you are looking for.
http://www.pyware.com/guide/3d/8.0/en/topic/3d-tutorial
I would suggest that you go through the tutorial. This will help you accomplish what you are looking for.
http://www.pyware.com/guide/3d/8.0/en/topic/3d-tutorial
Thank you
Dustin Merrell
Pyware Technical Support
940-240-8536
Dustin Merrell
Pyware Technical Support
940-240-8536