Drill mistakes
Moderator:PywareTechSupport
-
- Posts:3
- Joined:Sat Aug 21, 2010 12:00 am
Ok so i created a set tab on the wrong counts and made the drill for it and a couple tabs after as well. When i tried deleting the tab the drill was still moving to the same count structure. So i recreated the tab and tried moving the tab for set 5 back to the right count and it just keeps moving to the same count structure. and after moving each individual character one by one by one I still am dealing with crazy zig-zag pathways and all kinds of crazy stuff. Please help me.
Re: Drill mistakes
To adjust a transition that is too long or too short that is in a completed section of drill, the best option would be to use the count editor to either add or remove counts. This would allow you to adjust the transition accordingly. Once you have added or removed the counts then select the performers and choose the morph tool and press accept. This will refloat all of the performers over the new count structure.
-Dustin
Pyware Customer Support
-Dustin
Pyware Customer Support