Second drill Design Exhibition...Exhibition Thread

[greatcow95]

Place them here with at least a link to snag things.

If you haven't started yet, that's fine! Mine literally just got BORKED, so I'm back to square two (because I kind of remember what I wanted to do so it's not square 1). Just get it up by around the end of March or early April.

Don't know what's going on? Check out the link in my signature for the current exhibition guidelines.

PS--Hopefully we'll see the all-out war between Pyware Mark and Pyware Dustin.

[greatcow95]

In case anyone wants to see an example of what to post, here was mine from the first exhibition which finally got posted on Youtube:

https://www.youtube.com/watch?v=wy9UU2mWwtE

I'm halfway tempted to say "screw it" and use this one again, even though it doesn't follow the guidelines (there are 80 and not 84 winds). It's been a weird time for me in Pyware recently, but I'll try to get something posted before the end of the month with the current exhibition.

[greatcow95]

I finally got the last one finished. When I originally did the last piece of the drill, I had a catastrophic error (mine, not the application's) and had to do that entire piece all over again. Since it was a complex item, it was extremely time consuming.

Youtube link: https://www.youtube.com/watch?v=H3ZMRCqKUYk

[ossgraphics]

I was facing catastrophic error when I did the last piece of the drill in an original graphic manner. Thanks guys for sorting out my problem. You guys really rocks!